Workgroup Bridge Transmit/Receive - Cisco WAP 121 Administration Manual

WorkGroup Bridge Transmit/Receive

Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
REVIEW DRAFT Version 2—CISCO CONFIDENTIAL
• —The total number of errors related to sending and receiving data on
this AP.
You can click
information.
The WorkGroup Bridge Transmit/Receive page displays packet and byte counts
for traffic between stations on a workgroup bridge. For information on configuring
workgroup bridges, see
To display this page, click
navigation window.
The following information displays for each network interface that is configured as
a workgroup bridge interface:
•
•
administratively configured as up or down.
• —Virtual LAN (VLAN) ID. You can use VLANs to establish multiple
internal and guest networks on the same AP. The VLAN ID is set on the VAP
tab.
• —Wireless network name. Also known as the SSID, this
alphanumeric key uniquely identifies a wireless local area network. The
SSID is set on the VAP tab.
The following additional information displays for the transmit and receive direction
for each workgroup bridge interface:
•
clients in the workgroup bridge and the wireless network.
• —The total number of bytes bridged between the wired clients
in the workgroup bridge and the wireless network.
You can click
information.
to refresh the screen and display the most current
—Name of the Ethernet or VAP interface.
—Whether the interface is disconnected or is
—The total number of packets bridged between the wired
to refresh the screen and display the most current
.
> in the
17