Network Interfaces - Cisco WAP 121 Administration Manual

Network Interfaces

Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
REVIEW DRAFT Version 2—CISCO CONFIDENTIAL
•
the Active state display in the table. In the Active state, a connection is
established between the switch and a client or server. The TCP states are:
- —The service is listening for connection requests.
- —A connection session is established and packets are being
transmitted and received.
-
and a server or client, depending on each device's role with respect to
this protocol.
- —The closing sequence has been initiated and the AP is
waiting for a system-defined timeout period (typically 60 seconds)
before closing the connection.
You can click
information.
Use the Network Interfaces page to display configuration and status information
about the wired and wireless interfaces. To display this page, click
>
The Network Interfaces page displays the following information:
• —These settings apply to the internal interface. These include
the MAC Address; VLAN ID; IPv4 Address, subnet mask, and default
gateway; and the IPv6 address and default gateway. The two configured
DNS server IP addresses are also listed. For the WAP321 whether Green
Ethernet mode is enabled also displays.
To change any of these settings, click the Edit link. After you click Edit, you
are redirected to the LAN page. See
these fields.
• —These settings include the Wireless Radio mode (Enabled
or Disabled), the MAC address associated with each radio interface, the
802. 1 1 mode (a/b/g/n), and the channel used by the interface.
To change the wireless settings, click the Edit link. After you click Edit, you
are redirected to the Radio page. See
these fields.
—The state of the service. For UDP, only connections in
—A connection session is established between the switch
to refresh the screen and display the most current
in the navigation window.
for descriptions of
for descriptions of
15