Radio - Cisco WAP 121 Administration Manual

Radio

Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
REVIEW DRAFT Version 2—CISCO CONFIDENTIAL
Click >
In the Global Settings area, configure the
interval in seconds for the AP to report (through the system log and SNMP traps)
associated clients that do not adhere to mandatory admission control procedures.
In the Basic Settings area, configure the following settings:
• —Turns on or off the radio interface.
•
The MAC address is assigned by the manufacturer and cannot be changed.
• —The IEEE 802. 1 1 standard and frequency the radio uses.
The modes available depend on the country code setting.
Select one of the following modes:
- 802. 1 1a—Only 802. 1 1a clients can connect to the AP.
- 802. 1 1b/g—802. 1 1b and 802. 1 1g clients can connect to the AP.
- 802. 1 1a/n—802. 1 1a clients and 802. 1 1n clients operating in the 5-GHz
frequency can connect to the AP.
- 802. 1 1b/g/n (default)—802. 1 1b, 802. 1 1g, and 802. 1 1n clients operating in
the 2.4-GHz frequency can connect to the AP.
- 5 GHz 802. 1 1n—Only 802. 1 1n clients operating in the 2.4-GHz frequency
can connect to the AP.
- 2.4 GHz 802. 1 1n—Only 802. 1 1n clients operating in the 5-GHz frequency
can connect to the AP.
•
allows a 40 MHz-wide channel in addition to the legacy 20 MHz channel
available with other modes. The 40 MHz channel enables higher data rates
but leaves fewer channels available for use by other 2.4 GHz and 5 GHz
devices.
Set the field to 20 MHz to restrict the use of the channel bandwidth to a
20 MHz channel.
•
channel can be considered to consist of two 20 MHz channels that are
contiguous in the frequency domain. These two 20 MHz channels are often
in the navigation window.
—The Media Access Control (MAC) address for the interface.
(802. 1 1n modes only)—The 802. 1 1n specification
(802. 1 1n modes with 40 MHz bandwidth only)—A 40 MHz
—The time
37