Using External Equipment
12
Switching the optical audio signal type
Set up for the DIGITAL AUDIO output terminal (OPTICAL),
according to your AV receiver's operating instructions.
1
Press HOME MENU.
2
Select "Option". ( /
3
Select "Digital Audio Out". ( /
4
Select "Dolby Digital" or "PCM". ( /
Item
Description
Dolby Digital
Dolby Digital: outputs in the Dolby Digital format
(factory default)
PCM: outputs in the PCM format
PCM
Always outputs in the PCM format regardless of the
types of signals
5
Press HOME MENU again to exit the menu.
Watching an image from a computer
Connecting a personal computer
Use the PC terminals to connect a personal computer (PC).
NOTE
• The PC input terminals are DDC2B-compatible.
• Ability to use Plug & Play depends on the computer.
Plasma Display (rear view)
AV cable with a mini plug
(sold separately)
(for PC audio connection)
Personal Computer
72
En
then ENTER)
then ENTER)
then ENTER)
Viewed from the bottom
of the Plasma Display
RGB cable
(sold
separately)
Displaying an image from a PC
When connected to a PC, the input signal type is automatically
identified. If the image from the PC does not come in clearly,
you may need to use Auto Setup. See page 64.
To watch an image coming from the PC, press PC on the
remote control or press INPUT on the Plasma Display to select
"PC".
NOTE
• The PC terminals are for PC use only. Do not connect audio/
visual equipment to PC terminals.
Signal names for 15-pin mini D-sub connector
5
4
10
9
15
14
(front view)
Pin No.
Signal name
1
R
2
G
3
B
4
Not connected
5
Not connected
6
GND (ground)
7
GND (ground)
8
GND (ground)
9
+5V
10
GND (ground)
11
Not connected
12
SDA
13
HD
14
VD
15
SCL
NOTE
®
®
• An Apple
Macintosh
adaptor may be required for use with
some Macintosh computers.
3
2
1
8
7
6
13
12
11