Pioneer Elite PRO-1000HDI Operating Instructions Manual page 16

Installation and Connections
Connection of G ON SYNC analog RGB source
Make G ON SYNC connections for a personal computer
with output that has the synchronization signal layered on
top of the green signal.
When connecting to INPUT1
INPUT1
OUTPUT
ANALOG RGB (ANALOG RGB)
On screen setup is necessary after connection.
Please see pages 18 and 19.
When connecting to INPUT2
INPUT2
(ON SYNC) (H/V SYNC)
G B R HD VD
On screen setup is necessary after connection.
Please see pages 18 and 19.
Note
When making G ON SYNC connections, do not make any
connections to the VD or HD terminals. If connections are made,
the picture may be not displayed normally.
12
I I
PRO-1000HD / PRO-800HD
75 2.2
Ô
k
Connection of composite SYNC analog RGB
source
Make composite SYNC connections for a personal
computer with output that has the vertical
synchronization signal layered on top of the horizontal
synchronization signal.
When connecting to INPUT1
INPUT1
OUTPUT
ANALOG RGB (ANALOG RGB)
On-screen setup is necessary after connection.
Please see pages 18 and 19.
When connecting to INPUT2
(ON SYNC) INPUT2 (H/V SYNC)
G B R HD VD
When using INPUT2, set the impedance selector switch
to match the output impedance of the connected
computer's synchronization signal.
When the output impedance of the computer's
synchronization signal is below 75 , set this switch to
the 75 position.
On-screen setup is necessary after connection.
Please see pages 18 and 19.
Notes
÷ When making composite SYNC connections, do not connect
anything to the VD terminal. If connected, the picture may not
be displayed properly.
÷ On some types of Macintosh
®
composite SYNC are both output. With this type of
component, please connect using the G ON SYNC connection.
75 2.2
Ô
k
components, G ON SYNC and