Garmin Tri-Tronics PRO70 Owner's Manual page 14

Battery plate screws
Â
Battery plate
Ã
Battery
Ä
Gasket
Å
Front enclosure
Æ
Replacing the Pro 70 Dog Collar Device
Battery
Before you replace the battery, you must
remove all dirt, water, and debris from the
device. You also need a small Phillips
screwdriver and the security screwdriver
included with the battery replacement kit.
You can purchase a replacement battery
at http://buy.garmin.com. You should use
only an official Garmin replacement part.
1
Remove the six screws from the top
plate, and remove the top plate.
2
Remove the two screws from the
battery plate, and remove the battery
plate.
3
Grip the battery connector wires close
to the connector, and pull the
connector parallel to the circuit board
to disconnect the battery connector
from the device.
4
Remove the battery.
14
The battery fits tightly. It may be
necessary to pry the battery out of the
back plate using a non-sharp, non-
metal object.
5
Install the new battery into the front
enclosure with the label side of the
battery facing up, and the leading
edge of the battery placed under the
charging contact ledge of the device.
6
Replace the battery plate, and replace
and tighten the two screws.
7
Verify the gasket is not damaged and
is completely seated in the groove.
8
With the new battery, connect the
battery connector to the device.