Garmin Tri-Tronics PRO70 Owner's Manual page 12

Pro 70 Handheld Device Components
Security screws
À
Back plate
Á
Battery plate screws
Â
Gasket
Ã
Battery plate
Ä
Battery
Å
Replacing the Pro 70 Handheld Device
Battery
Before you replace the battery, you must
remove all dirt, water, and debris from the
device. You also need a small Phillips
screwdriver and the security screwdriver
included with the battery replacement kit.
12
You can purchase a replacement battery
at http://buy.garmin.com. You should use
only an official Garmin ® replacement part.
1
Remove the eight security screws
from the back of the device.
2
Lift up the back plate.
3
Grip the battery connector wires close
to the connector, and pull the
connector perpendicular to the circuit
board to disconnect the battery
connector from the device.
4
Grip the rotary switch connector wires
close to the connector, and pull the
connector perpendicular to the circuit
board to disconnect the rotary switch
connector from the device.
5
Remove the two screws from the
battery plate.
6
Lift up the battery plate.
7
Remove the old battery from the back
plate, noting the orientation of the
battery.
The battery fits tightly. It may be
necessary to pry the battery out of the
back plate using a non-sharp, non-
metal object.