Selecting A Standard Display - Sennheiser SK 500 G3 User Manual

Bodypack transmitter for a wireless microphone

Hide thumbs Also See for SK 500 G3:

Instruction manual (40 pages)

Specifications (3 pages)

Comprehensive manual (28 pages)

Table of Contents

ew G3 SK 500_529695_0109_SP8_PRT.book Seite 13 Donnerstag, 5. Februar 2009 12:43 12

From the

"Mute

Mode" menu item, select the desired setting

(see pagec20).

Exit the operating menu.

Slide the

MUTE

switch

to the left, to the position MUTE.

The bodypack transmitter reacts as indicated in the table.

The current state of the muting function or the RF signal is displayed on

the display panel of the bodypack transmitter. An additional display

appears on the receiver's display panel when the pilot tone function is acti-

vated on both bodypack transmitter and receiver and, in addition, this

display has been activated via the "Warnings" menu item on the receiver

(see the instruction manual of the receiver).

Audio signal is muted

Transmitter's display panel:

Receiver's display panel:

only when activated on the receiver (see above)

Audio signal is activated (muting is deactivated)

Transmitter's display panel:

Receiver's display panel:

RF signal is deactivated

Transmitter's display panel:

Receiver's display panel:

only when activated on the receiver (see above)

RF signal is activated

Transmitter's display panel:

Transmission icon

Receiver's display panel:

"RF

You can also deactivate the RF signal on switch-on. For more

information, refer to the chapter "Switching the bodypack trans-

mitter on/off" on page 11.

Using the

ON/OFF

button, you can also activate/deactivate

the RF signal during operation. To do so, briefly press the

ON/OFF

button and proceed as described on page 11.