Setting Up Sata Mode (Optane™ Or Ahci); Ahci Mode; Intel® Optane; Intel® Rapid Storage Technology Application - Clevo N850HP6 User Manual

Modules

SATA Mode
Selection
The SATA mode selec-
tion should be made be-
fore installing
operating system.
DO NOT change your
6
selected SATA mode
unless you intend to re-
install your operating
system. Make sure you
have backed up all your
data before doing so.
See "SATA Mode (Ad-
vanced Menu)"
page 5 - 9.
6 - 2 Setting Up SATA Mode (Optane™ or AHCI)
Setting Up SATA Mode (Optane™ or AHCI)

AHCI Mode

Advanced Host Controller Interface (AHCI) is an interface specification that allows
the storage driver to enable advanced serial ATA features such as Native Command
Queuing (for maximum hard disk efficiency and performance). Make sure you in-
stall the Intel® Rapid Storage Technology application to support your HDDs/
your
SSDs in AHCI mode (see
Intel® Optane™
Intel® Optane™ is a combination of a compatible memory device and Intel Rapid
Technology software. This combination is designed to speed up your system per-
formance by caching boot data, executables, frequently accessed data and system
page files to an non volatile, low latency Intel® Optane™ SSD.
Contact your distributor or supplier to see if your system supports this technology.
Intel Rapid Storage Technology Application
®
on
Make sure you install the Intel® Rapid Storage Technology application if you
have set up your system in Intel RST Premium (for Intel
"Intel® Rapid Storage Technology" on page 6 -
After setting the SATA mode to Intel® Optane™ and installing the Intel® Rapid
Storage Technology application, DO NOT uninstall the Intel® Rapid Storage
Technology application.
"Intel® Rapid Storage Technology" on page 6 -
19).
19).
Optane ) mode (see
® ™