Clean The Inlet Filter - Titan ControlMax 1500 Operating Manual

SPRAYING TROUBLEShOOTING - CLEAN ThE INLET FILTER
If the spray pattern becomes distorted or stops spraying
i
completely while the gun is triggered, the inlet filter
could be clogged. Follow the steps below.
YOU wILL NEED
•
Warm, soapy water for latex material
•
Mineral spirits for oil based materials
Make sure your floors and furnishings are covered
with drop cloths to prevent accidental drips.
Attention
1.
Remove the inlet filter by pulling it off the suction tube.
2.
Clean the screen using the appropriate cleaning solution
(warm, soapy water for latex materials, mineral spirits for oil-
based materials).
3.
Snap the inlet filter back into place.
If after completing all of the steps in Spraying
i
Troubleshooting
problems spraying, refer to the Troubleshooting
section (page 22).
you are still experiencing
EN
1
2
3
15