If The Picture Freezes And The Front Panel And Remote Control Buttons Stop Working - Pioneer DVR-LX60D Operating Instructions Manual

Additional information
17
HDMI
Problem
The connected HDMI or
DVI device does not
display any picture
(and the front panel
HDMI indicator does
not light)
No video from the
HDMI output
There's no sound from
the connected HDMI or
DVI device
If the unit does not operate normally due to external effects such as static electricity, disconnect
the power plug from the outlet and insert again to return to normal operating conditions.
If the picture freezes and the front panel and remote control
buttons stop working
• Press (Stop) then try restarting
playback.
• Press the front panel
button to switch the power off, then
switch back on and restart playback. If
the power fails to switch off, press and
STANDBY/ON for five seconds
hold
150 until the power switches off.
En
Remedy
• Try disconnecting then reconnecting the HDMI cable (while the
power of both components is on).
• Try switching the power of the HDMI/DVI device off then back on.
• Try switching off the HDMI/DVI device and this recorder. Next,
switch on the HDMI/DVI device and leave it for around 30 seconds,
then switch on this recorder.
• When you connect an HDMI-compatible device make sure of the
following:
– The connected device's video input is set correctly for this unit.
– The cable you're using is fully HDMI-compliant. Using a non-
standard cable may result in no picture being output.
– Don't use several HDMI cables connected together. Use a single
cable to connect devices together.
• When you connect a DVI-compatible device make sure of the following:
– The connected device's video input is set correctly for this unit.
– The DVI terminal on the connected device is HDCP-compatible.
– The connected device is compatible with NTSC (720 x 480i/p,
1280 x 720p, 1920 x 1080i/p) and PAL (720 x 576i/p, 1280 x 720p, 1920 x
1080i/p) video input.
• If the recorder's internal HDD is damaged or broken, there will be no
HDMI output.
• Not all HDCP-compatible DVI devices will work with this recorder.
• If you choose a setting that is incompatible with your TV you may not
be able to see any picture at all. In this case, press
while holding down the
the setting (this also switches Component Video Out on page 131 to
the default setting).
• There is no sound when using a DVI terminal.
• Some HDMI-compatible devices do not output sound (check with
the manual that came with the connected device).
STANDBY/ON
(Stop) button on the front panel to switch
STANDBY/ON
HDD/DVD
A.TV D.TV PLTV DivX COPY
STANDBY/ON DV IN USB
OPEN/CLOSE
OPEN/CLOSE
COMMON INTERFACE
STOP REC
INPUT
CH
SELECT