Pioneer DVR-530H-S Operating Instructions Manual page 41

Recording
4 Select 'Store Program' to finish.
• Other options in the same menu panel allow you to
name the program, and change the recording
destination and/or recording mode.
G-Code programming with the power off
You can enter a G-Code programming number when the
recorder is in standby.
Note that the recording is always made to the HDD. If you
want to record to a DVD disc, you'll need to switch on the
power and use the full G-Code program screen.
HDD
G
-CODE
+
Important
• You can't use this feature until you have set up the
guide channels. See G-Code CH Setting on page 93.
• You can't change the recording mode.
• You can't program daily or weekly timer recordings.
1 Press 'G-Code'.
The front panel display shows the current recording
mode and prompts you to enter the G-Code programming
number.
2 Use the number buttons to enter the number.
• To clear the last digit entered, press CLEAR.
3 Press ENTER.
The display shows the timer settings:
Date Start time End time
channel Recording mode.
• If CODE ERROR appears in the display, check that
the number is correct and that the guide channel is
set (see G-Code CH Setting on page 93), then set the
timer recording again.
• If CAN'T SET appears in the display, it means that
although you entered a valid number, the program
has already finished.
DVD
CH
CLEAR
CLEAR
ENTER
HDD and Recording
Setting a manual timer recording
The timer recording screen you can see all the timer
programs already set, clear programs and set up new
ones.
HOME
MENU
PREV NEXT
1 Press TIMER REC to display the Timer Recording
screen.
You can also access the Timer Recording screen from
the Home Menu (press HOME MENU, select Timer
Recording, then Timer Recording).
This screen shows all the timer programs currently set.
Timer Program View
SAT 26/3 15:00
Manhattan Open Tennis
SAT 26/3 18:00 – 21:00
World Journey
SUN 27/3 19:30 – 21:00
Flower
MON – FRI 13:30 – 14:00
HDD Remain
DVD Remain
• Each row is for one timer recording program, with the
date and time information, channel, recording mode,
DVD or HDD and recording status.
• The amount of free space available on the HDD and
the currently loaded recordable DVD is shown
towards the bottom of the screen.
• In the upper-right corner, the number of timer
programs already set is shown next to Tmr Pgms.
• If there are more than five timer programs already
set, press NEXT to switch page (go back using
the PREV
button).
• You can also delete a timer program before it's
started (before the recorder enters timer recording
standby) by highlighting it and pressing CLEAR. See
also Deleting a timer program on page 43.
CLEAR
CLEAR
ENTER
TIMER REC
Tmr Pgms 4/32
OK
Pr 10
OK
Pr 4
Until 30/4
Pr 8
New Input
59h59m(SP)
1h59m(SP)
05
41
En