Pioneer DVR-530H-S Operating Instructions Manual page 31

Getting started
Playing CDs and WMA/MP3 discs
The table below shows the basic playback controls for
1
audio CDs , and WMA/MP3 files.
Press to start playback.
PLAY
Press to stop playback.
STOP
Pauses playback, or restarts playback
PAUSE
when paused.
Press to start scanning. Press again to
REV SCAN FWD SCAN
increase the scanning speed. (There are
two scan speeds; the current scan speed
is shown on-screen.)
Press to skip to previous/next track (or
PREV NEXT
folder for WMA/MP3 disc). (During play-
back you can also use the front panel +/–
buttons.)
During playback, enter a track number
then press ENTER to skip directly to that
track.
Press CLEAR to clear a number entry and
CLEAR
start again.
CLEAR
ENTER
Note
1. If you want to play a DTS audio CD, make sure the recorder is connected to a DTS-compatible amp/receiver with a digital connection. Noise
will be output through the analog outputs. Also make sure that STEREO is selected using the AUDIO button (see Switching audio channels
on page 58).
2. When playing in PBC mode, some playback features, such as search, repeat and program play are not available. You can play a PBC Video
CD/Super VCD in non-PBC mode by pressing
Playing Video CD/Super VCDs
The table below shows the basic playback controls for
Video CD/Super VCDs.
Some discs feature Playback Control (PBC for short)
menus. These discs show PBC in the display when you
load them and display a menu on-screen from where you
can select what to watch.
PLAY
REV SCAN
PREV
BACK
STEP/SLOW
to start playback instead of PLAY.
2
Press to start playback.
Video CD only: If RESUME is displayed on-
screen, playback starts from the place last
stopped.
Press to stop playback.
STOP
Video CD only: You can resume playback
from the same point by pressing
STOP again to cancel the resume
(Press
function.)
Pauses playback, or restarts playback
PAUSE
when paused.
Press to start scanning. Press repeatedly
FWD SCAN
to increase the scanning speed.
Press to skip to previous/next track.
NEXT
When a PBC menu is displayed, press to
display the previous/next page. (During
playback you can also use the front panel
+/– buttons.)
During playback, enter a track number
then press ENTER to skip directly to that
track.
Press CLEAR to clear a number entry and
CLEAR
start again.
CLEAR
While a PBC menu screen is displayed,
use to select numbered menu items.
ENTER
Video CD only: Each press skips backward/
CM
SKIP
forward progressively up to a maximum of
ten minutes forward or three minutes
back. Note that this function doesn't work
when playing in PBC mode.
During playback, press to start slow-
motion playback. Press repeatedly to
change the playback speed (forward only).
While paused, press to advance a single
frame (forward only).
Press to display the disc menu of a Video
RETURN
CD/Super VCD playing in PBC mode.
04
PLAY.
31
En