Rf Calltest In Nokia Cdma L3 Pst Fx.x - Nokia 2608 Service Manual

RM-376
RF Troubleshooting

RF CallTest in Nokia CDMA L3 PST Fx.x

Context
Always start the troubleshooting procedure by running the RF CallTest in Nokia CDMA L3 PST. If a test fails, please
follow the diagram below.
If the phone is dead and you cannot perform the self tests, go to Dead or jammed device troubleshooting in the
baseband troubleshooting section.
Setup for RX Troubleshooting
Use the following steps to configure FTM mode for RF troubleshooting.
1. Connect RF connector to a spectrum
2. Put PWB on the module jig, connect data service cable between PC and Module Jig and connect a power
supply
3. Launch Nokia CDMA L3 PST Fx.x Service Software and run RF Toolkit function
4. The RF and Testing box appears
5. Select "RF and Testing "
6. Press "START" Button
Issue1 Company Confidential
Copyright © 2008 Nokia. All rights reserved.
Page 4-9