Pioneer DVR-440H-S Operating Instructions Manual page 19

Connecting up
SCART AV
CONNECTOR
2
TV
AV 1 (RGB) – TV
Y
AC IN
P B
OUTPUT
DIGITAL CONTROL
R
OUT
P
R
COAXIAL IN G-LINK COMPONENT
VIDEO OUT
4
SCART AV
3
CONNECTOR
Cable/Satellite/
Digital Terrestrial
receiver
1 Connect RF antenna cables as shown.
This enables you to watch and record TV
channels.
2 Use a SCART cable (not supplied) to
connect the AV1(RGB)-TV AV connector
to a SCART AV connector on your TV.
This enables you to watch discs.
3 Use another SCART cable to connect
the AV2(INPUT 1/DECODER) AV
connector to a SCART AV connector on
your cable box/satellite/digital terrestrial
receiver.
This enables you to record scrambled TV
channels.
ANTENNA
IN
1
ANTENNA
IN (RF IN)
AV 2 (INPUT 1/DECODER)
IN
L
OUT
ANTENNA
AUDIO VIDEO
S-VIDEO
ANTENNA
OUT
ANTENNA
1
OUT
ANTENNA
IN
1
Satellite dish/
antenna/cable TV
wall outlet
4 Plug the supplied G-LINK™ cable to
the G-LINK™ jack.
This enables you to control the tuner in the
external receiver using the GUIDE Plus+®
system.
Position the IR transmitter end of the G-
LINK™ cable so that the IR receiver on your
cable/satellite/digital terrestrial receiver will
pick up the control signals (see diagram).
G-LINK cable
See the manual that came with your cable/
satellite/digital terrestrial receiver if you're
not sure where the IR receiver is on the front
panel. Alternatively, experiment with the
remote control, operating it from very close
range until you find the place where the
receiver responds.
Tip
• This recorder has a 'through' function
which allows you to record a TV program
from the built-in TV tuner in this recorder
while watching a video playing on your
VCR. (To use this feature when the
recorder is in standby, Power Save
must be set to Off—see Power Save on
page 116).
02
AV 1 (RGB) – TV
Y
P
B
OUTPUT
DIGITAL CONTROL
OUT R L
P
R
COAXIAL IN G-LINK COMPONENT AUDIO
VIDEO OUT
19
En