Connecting To A Cable Box, Satellite Receiver Or Digital Terrestrial Receiver - Pioneer DVR-440H-S Operating Instructions Manual

02
Connecting up
Using the S-video or component
video output
COMPONENT
VIDEO INPUT
AUDIO
INPUT
2
TV
AC IN
1 Connect the S-video or component
video output to a similar input on your
TV.
For an S-video connection, use an S-video
cable (not supplied) to connect the S-VIDEO
OUTPUT jack to an S-video input on your TV.
For a component video connection, use a
component video cable (not supplied) to
connect the COMPONENT VIDEO OUT
jacks to a component video input on your TV.
See also Component Video Out on page 119
for how to set up the component video
output for use with a progressive scan-
compatible TV.
2 Connect the AUDIO OUTPUT jacks to
the corresponding audio inputs on your
TV.
You can use the supplied audio/video cable,
leaving the yellow video plug disconnected.
Make sure you match up the left and right
outputs with their corresponding inputs for
correct stereo sound.
Note
1 The diagram shows SCART video connections, but you can alternatively use any of the other audio/video con-
nections.
18
En
S-VIDEO
INPUT
AV 1 (RGB) – TV AV 2 (INPUT 1/DECODER)
Y IN
P
B
OUTPUT
DIGITAL
CONTROL
OUT R L
OUT
P
R
ANTENNA
COAXIAL IN G-LINK COMPONENT AUDIO VIDEO
S-VIDEO
VIDEO OUT
Connecting to a cable box,
satellite receiver or digital
terrestrial receiver
If you have a cable, satellite or digital
terrestrial receiver with a built-in decoder,
connect it to this recorder and your TV as
1
shown on the following page.
using a separate decoder box for your cable/
satellite TV, set up following the instructions
on the next page.
Using the setup on this page you can:
• Record any channel by selecting it on
the cable box, satellite receiver or digital
terrestrial receiver.
• Change channels and set timer
recordings on the external receiver using
the GUIDE Plus+® system (via the
G-LINK™ cable, and after setting up).
Important
• Do not connect this recorder to your TV
'through' your VCR, satellite receiver or
other component. Always connect each
component directly to your TV or AV
amplifier/receiver.
• When using the GUIDE Plus+ system to
make a timer recording from an external
receiver, make sure that the external
receiver is switched on.
1
If you are