On-Screen Displays And Recorder Displays - Pioneer DVR-220 Operating Instructions Manual

Pioneer dvd recorder dvr-220, dvr-320 operating instructions
Hide thumbs Also See for DVR-220:
Table of Contents

Advertisement

Additional information
13

On-screen displays and recorder displays

The table below shows a list of error messages that you may encounter when using the recorder and an explanation
of their meaning.
Message
• Initializing disc. Please wait a moment.
• Incompatible region number.
• Cannot record any more titles.
• No more space for file management data.
• Cannot add any more chapter marks.
• This disc cannot be recorded. Undo the final-
ization.
• Cannot play this disc.
• This disc cannot be recorded.
• Cannot read the CPRM information.
• Could not record the information to the disc.
• Cannot edit.
• Could not initialize disc.
• Could not complete finalization successfully.
• Could not undo finalization successfully.
• Could not successfully unlock the disc.
• Cannot record to a disc that is not CPRM com-
patible.
• Cannot record this content using Video mode
recording.
• This content is copy protected.
• Incorrect CPRM information.
• The audio will conform to the [Dual Mono
Recording] setting.
• Operation stopped due to power failure.
• Could not repair the disc.
• Overheating has stopped operation.
Press DISPLAY to clear this message.
(DV-320 only)
• No DV input.
• Cannot preview because there is no DV input.
94
En
Explanation/Action
When you load a blank DVD-RW disc, the recorder automatically
initializes it.
The disc loaded has an incompatible region number for the
recorder and so will not play.
The disc control data limit has been reached, or the maximum
number of chapters and/or titles has been reached. Erase titles/
chapters or combine chapters.
The disc was finalized on a non-Pioneer DVD recorder. Undo the
finalization in order to recording/editing.
The disc may be dirty or damaged. Take out the disc, clean it and
retry. If the error persists, use a new disc. If the error appears even
with a new disc, please consult a Pioneer Service Center.
The video source is copy-once protected. Use a VR mode DVD-RW
disc with CPRM for recording.
The video source is copy-protected and cannot be recorded.
The recorder could not read the CPRM information. The recorder
may be damaged—please consult a Pioneer Service Center.
When recording from an external input in Video mode, or in VR
mode set to MN 32, audio is recorded in Linear PCM format. You
can only record the left or right channel; not both.
If during recording the power plug is disconnected from the power
outlet, this message will be displayed the next time the recorder is
switched on. In this case, the recording will not be recoverable.
The recorder was unable to repair the disc after a power cut. The
contents of the recording will be lost.
The internal temperature of the recorder has exceeded the
operating limit. If this message reappears, please contact a
Pioneer authorized service center.
No signal was detected at the DV input/output jack. This may
appear if a blank section of DV tape is playing in the connected
camcorder.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dvr-320-sDvr-320

Table of Contents