On-Screen Displays And Recorder Displays - Pioneer DVR-5100H Operating Instructions Manual

Additional information

On-screen displays and recorder displays

The table below shows a list of error messages that you may encounter when using the recorder and an explanation
of their meaning.
Message
• Initializing disc. Please wait a moment.
• Incompatible region number.
• Cannot record any more titles.
• No more space for file management data.
• Cannot add any more chapter marks.
• This disc cannot be recorded. Undo the final-
ization.
• Cannot play this disc.
• This disc cannot be recorded.
• Cannot read the CPRM information.
• Could not record the information to the disc.
• Cannot edit.
• Could not initialize disc.
• Could not complete finalization successfully.
• Could not undo finalization successfully.
• Could not successfully unlock the disc.
• Cannot record to a disc that is not CPRM com-
patible.
• Cannot record this content using Video mode
recording.
• This content is copy protected.
• Incorrect CPRM information.
• No DV input.
• Cannot preview because there is no DV input.
• The audio will conform to the [Bilingual
Recording] setting.
• Repairing disc.
• Could not repair the disc.
• Overheating has stopped operation.
Press DISPLAY to clear this message.
• Playback has stopped because the TV system is
different than the recording.
Explanation/Action
When you load a blank DVD-RW disc, the recorder automatically
initializes it.
The disc loaded has an incompatible region number for the
recorder and so will not play.
The disc control data limit has been reached, or the maximum
number of chapters and/or titles has been reached. Erase titles/
chapters or combine chapters.
The disc was finalized on a non-Pioneer DVD recorder. Undo the
finalization in order to recording/editing.
The disc may be dirty or damaged. Take out the disc, clean it and
retry. If the error persists, use a new disc. If the error appears even
with a new disc, please consult a Pioneer Service Center.
The video source is copy-once protected. Use a VR mode DVD-RW
disc with CPRM for recording.
The video source is copy-protected and cannot be recorded.
The recorder could not read the CPRM information. The recorder
may be damaged—please consult a Pioneer Service Center.
No signal was detected at the DV input/output jack. This may
appear if a blank section of DV tape is playing in the connected
camcorder.
When recording from an external input in Video mode, or in VR
mode set to MN 32, audio is recorded in Linear PCM format. You
can only record the left or right channel; not both.
During recording, the power was cut. This display appears when
the power is restored.
The recorder was unable to repair the disc after a power cut. The
contents of the recording will be lost.
The internal temperature of the recorder has exceeded the
operating limit. If this message reappears, please contact a
Pioneer authorized service center.
During recording or timer recording standby, the Line System of
the playback video changed, causing playback to stop
automatically.
14
119
En