Pioneer DVR-320-S Operating Instructions Manual page 48

Recording
06
1 Press 'G-Code' to display the G-Code program
screen.
You can also access this screen from the Home Menu
(press HOME MENU, select Timer Recording, then G-
Code).
G-Code
G-Code#
MN21
Rec Mode
Once
Rec Times
•
number buttons to enter the G-Code programming
number. (To clear the last digit entered, press
CLEAR.)
• Press REC MODE to select FINE, SP, LP, EP or AUTO
(See Recording time and picture quality on page 42). If
Manual Recording is on, then you can also select the
MN setting.
• Use the
Once, Daily or Weekly recording option.
2 After making the settings, press ENTER.
The program details are shown at the bottom of the
screen for a few seconds then the screen is automatically
exited.
• If you haven't set up the guide channels (or at least
the guide channel for the number that you entered),
the recorder will prompt you to enter the channel
number that the TV program is showing on.
Tip
• You can check the timer program settings by
pressing TIMER REC to display the timer recording
screen.
G-Code programming with the power off
You can enter a G-Code programming number when the
recorder is in standby.
48
En
3 9 9 2 4 0 9
to input
REC MODE
to change
to change level
Daily Weekly
to change
(cursor left/right) buttons to select the
G-
CODE
CLEAR
ENTER
Important
• You can't use this feature until you have set up the
guide channels. See G-Code CH Setting on page 77.
• You can't change the recording mode.
• You can't program daily or weekly timer recordings.
1 Press 'G-Code'.
The front panel display shows the current recording
mode and prompts you to enter the G-Code programming
number.
Use the
2 Use the number buttons to enter the number.
• To clear the last digit entered, press CLEAR.
3 Press ENTER.
The display shows the timer settings:
Date Start time
• If CODE ERROR appears in the display, check that
the number is correct and that the guide channel is
set (see G-Code CH Setting on page 77), then set the
timer recording again.
• If CAN'T SET appears in the display, it means that
although you entered a valid number, the program
has already finished.
Extending a timer recording in progress
You can extend a timer recording beyond the
programmed end time in two different ways. This can be
useful if a broadcast program overruns, for example.
G - COD E
2 9 32 4
End time Recording channel.
CLEAR
ENTER
HOME
MENU
PREV NEXT
REC STOP REC
TIMER REC