Connecting Using The S-Video Output; Connecting Using The Component Video Output - Pioneer DVD-V5000 Operating Instructions Manual

02 Connecting up
Connecting using the
S-video output
If your TV (or other equipment) has an S-video
input, you can use this instead of the standard
(composite) output for a better quality picture.
• Use an S-video cable (not supplied) to
connect the S-VIDEO OUT to an S-video input
on your TV (or monitor or AV receiver).
Line up the small triangle above the jack with the
same mark on the plug before plugging in.
TV
• When COMPONENT VIDEO OUT is set to
Progressive, there is no video output from
the S (S-video) jack. If you want to display
video on the monitor, make sure that it is set
to Interlace. Press PROGRSSIVE on the
front panel to switch the player back to
Interlace.
12
Connecting using the
component video out-
put
You can use the component video output instead
of the standard video out jack to connect this
player to your TV (or other equipment). This
should give you the best quality picture from the
three types of video output available.
• Use a component video cable (not sup-
plied) to connect the COMPONENT VIDEO
OUT jacks to a component video input on
your TV, monitor or AV receiver.
S-VIDEO
IN
TV
• Only NTSC video is output when set to
• To set up the player for use with a progres-
progressive scan.
sive scan TV, see About progressive scan
video on page 15.
COMPONENT
VIDEO IN