Merging Groups - Pioneer DVD-V5000 Operating Instructions Manual

Barcode Stack / Command Stack
Merge Groups
1 Use the (cursor up/down) buttons
to select the next available step.
.
• The group divider (***) appears here.
Command Stack
Group(1-002) Command(1-002)
Group001 001 02:000150-002050
Group002 002 06:22-23
003
004
005
006
007
008
Move Select ENTER
2 Press ENTER.
3 Use the (cursor up/down) buttons
to select "COMMAND" then press ENTER.
Command Stack
Group(1-002) Command(1-002)
Group001 001 02:000150-002050
Group002 002 06:22-23
003
SEGMENT PLAY
004
CHAPTER PLAY
005
COMMAND
006
007
008
Move Select ENTER
4 Use the (cursor up/down) buttons
to select "MERGE GROUP."
Command Stack
Group(1-002) Command(1-002)
Group001 001 02:000150-002050
PLAY
Group002 002 06:22-23
STEP REV
003
WAIT
004
REPEAT GROUP
005
GO TO GROUP
006 DIVIDE GROUP
MERGE GROUP
007
008
Move Select ENTER
* * *
Delete CLEAR Exit HOME MENU
* * *
Return RETURN Exit HOME MENU
PAUSE STOP
* * *
STEP FWD
000 sec.
000
Return RETURN Exit HOME MENU
5 Press ENTER.
Command Stack
Group(1-001) Command(1-005)
Group001 001 02:000150-002050
002 06:22-23
003 PLAY
004 03:123000-129000
005 05:03-07
006
007
008
Move Select ENTER
• The group divider is erased and the
previous group is joined with the following
group.
• The group number isadjusted for each
subsequent group.
.
6 Save the change.
• Merges are only saved when OK is
highlighted and ENTER is pressed.
If "CANCEL" is highlighted when the
ENTER button is pressed, all merges
are reversed.
• If the power is interrupted while saving a
barcode stack/command stack during
video playback and the disc is still spinning,
the settings are not recorded.
.
When disconnecting the power cord, always
turn off the main power switch first (the
power indicator is not lit) or use the remote
control to set the unit to Standby mode (the
power indicator changes to red).
.
* * *
03 2 1
Return RETURN Exit HOME MENU
10
61