Troubleshooting; General - Pioneer DV-989AVi-G Operating Instructions Manual

Additional information

Troubleshooting

Incorrect operation is often mistaken for trouble or malfunction. If you think that there is some-
thing wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Inspect the other components and electrical appliances being used. If the
trouble cannot be rectified after checking the items below, ask your nearest Pioneer authorized
service center or your dealer to carry out repair work.

General

Problem
The disc won't play or is
automatically ejected after
loading.
DVD-Audio playback stops. • The disc may have been illegally copied.
Picture playback stops and
the operation buttons
cannot be used.
New settings made in the
Setup screen menus while
a disc is playing are
ineffective.
Settings are canceled.
Remedy
• Make sure the disc is free from dirt and dust and is not damaged
(see Taking care of your player and discs on page 76).
• Make sure the disc is loaded with the label side face-up and aligned
properly in the disc tray guide.
• Incompatible region number: If the region number on a DVD-Video
disc does not match the number on the player, the disc cannot be
used (see DVD-Video regions on page 11).
• Condensation inside the player: Allow time for condensation to
evaporate. Avoid using the player near an air-conditioning unit.
• Press , then start playback again ( ).
• Switch the power off once, unplug from the wall socket, then plug
back in and switch on again by
the player on.
• Some settings can be changed while a disc is playing, but are not
effective until the disc is stopped then restarted: Press
playback again ( ).
• When the power is cut due to power failure or by unplugging the
power cord during operation, settings will be canceled. See Moving
the player on page 77 for proper shutdown instructions.
STANDBY/ON to switch
pressing
09
, then start
87
En