Yamaha Star Owner's Manual page 73

1. Wheel axle
2. Front wheel axle pinch bolt
3. Raise the front wheel off the
ground. (See page 7-35.)
4. Remove the wheel axle, and then
remove the wheel. NOTICE: Do
not apply the brake after the
wheel and brake disc have been
removed, otherwise the brake
pads will be forced shut.
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
Periodic maintenance and adjustment
1. Speedometer gear unit
2. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
[ECA11073]
1. Speedometer gear unit
2. Retainer
3. Speedometer cable
3. Install the wheel axle.
4. Lower the front wheel so that it is
5. Tighten the wheel axle to the
6. Tighten the front wheel axle pinch
7-36
on the ground, and then put the
sidestand down.
specified torque.
Tightening torque:
Wheel axle:
59 N·m (5.9 kgf·m, 43 lb·ft)
bolt to the specified torque.
Tightening torque:
Front wheel axle pinch bolt:
20 N·m (2.0 kgf·m, 14 lb·ft)
7