Advertisement
Installing the Flat Port
1. First check to see that there is a thin film of lubricant on the Port Base
O-ring. The o-ring should appear slick. If necessary, relubricate with the
supplied Ikelite lubricant. Do not use excessive lubricant which can
attract hair or other debris. Use ONLY Ikelite lubricant.
2. Make sure the o-ring is free of hair or other debris.
3. Lift and REMOVE the gear sleeve from inside the Port Base. Place the
Gear Sleeve in storage for later use with the Dome Port.
4. Slide the Flat Port over the Port Base until it STOPS, Diagram C, Page
5. When properly installed, there should only be an approximate 3/32"
gap between the bottom of the Port and the front of the housing,
Diagram A, Page 2.
6. Snugly tighten the 3 thumb screws into the Port Base. DO NOT
overtighten. No Thumb Screw threads will be visible once the Port is
properly secured.
*
The gear sleeve must be removed BEFORE using the Flat Port.
*
We recommend placing the closed housing in a pool or bathtub to
assure proper installation and watertightness before installing your
camera.
4
Advertisement
