Assembly - Healthrider 15.5 S User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove all
packing materials; do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires an adjustable wrench , a Phillips
screwdriver , and a rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware
kit, check to see if it has been preassembled.
M8 Split M8
M10 Split Upper Body Arm M10
Washer (28)–4 Washer (45)–2 Washer (71)–4 Washer (55)–2
Washer (35)–2
Console Screw
Wave Large Wave M8 Locknut M10 Locknut (59)–4
(38)–4 (33)–6
Washer (69)–2 Washer (76)–2
M4 x 22mm
M8 x 25mm Patch
M8 x 52mm Button
M10 x 27mm
Screw (63)–2
Screw (56)–2
Screw (27)–4 Patch Screw (40)–2
M10 x 74mm Button Bolt (7)–2 M10 x 75mm Carriage Bolt (34)–4
M8 x 45mm Button Bolt (50)–4
M10 Bolt Set (25)–2
5