Chapter 2 - Placing Your AirStation
Antenna Placement
Remove the antenna cap, and attach the supplied antenna here. The antenna connector can be
easily damaged, and so be careful not to touch it.
Note: The supplied antenna supports both the 2.4 GHz and 5 GHz bands.
Installation
Connecting Power Sourcing Equipment (Sold Separately)
If PoE (Power over Ethernet) enabled power sourcing equipment (sold separately) is used to provide
power to the AirStation, perform the procedure below to connect the power sourcing equipment.
Notes:
· Power sourcing equipment can be connected to the LAN 1 port only. The LAN 2 port does not support PoE,
and so do not connect power sourcing equipment to this port. Doing so could cause a breakdown of the
device.
· PoE is a function compliant with the IEEE802.3af or IEEE802.3at standards, and it enables data signal
transmission and powering of devices over a single LAN cable. A device with a PoE function can be used
without connecting a power cable by simply connecting it to an AirStation with a LAN cable.
· If power is supplied using PoE, do not connect an AC adapter.
· Some power sourcing equipment may be unable to supply power to the AirStation depending on its
specifications. Be sure to always use power sourcing equipment that is compatible with the AirStation.
- 8 -