Battery Replacement; Cleaning And Maintenance - jablotron nanny Manual

eping or other equipment that vibrates. Interfering shocks can also be caused by intensive air circulation
(fans, air conditioning, etc.), people walking near the crib and other factors. If you move the crib to a new
place or if you turn on a new appliance that generates mechanical vibrations in your home (interfering
vibrations preventing the device from monitoring the baby's breathing), we recommend that you test the
function of the BM-02 Nanny.
You should avoid using mattresses made of hard materials (foam polystyrene, etc.) that absorb disturbing
vibrations caused by the movement of the ambient air.
Bear in mind that the device can only warn you in the case of an emergency but that it does not prevent
the risk of a breathing stoppage! If the baby has any physical problem, it is up to you or your doctor to
provide appropriate help. Do not stay too far from your baby to make sure that you hear the alarm, should
it go off, and that you are able to respond.
The manufacturer is responsible for the functionality of the BM-02 Nanny provided it is installed and
used in accordance with this manual. The manufacturer waives any responsibility for the proper func-
tionality of the product in the event that it is mechanically or otherwise damaged or for battery defects.
Moreover, the manufacturer waives any responsibility in the event that the product has been used in
contradiction to this user manual.
The manufacturer urges you not to purchase a used product or to get it from a rental store. Rough han-
dling may reduce the sensitivity of the sensor, which may have its consequences. Should this be the case
the manufacturer waives all responsibility for the functionality of the product.
The device checks its battery status. When the batteries are running low, necessary replacement is signaled
by the indicator fl ickering red. Also, the device does not confi rm the activation of the switch when the ba-
tteries are discharged. Turn off the device before replacing the batteries. Remove the battery compartment
cover (see the Installation Instructions – page 14) and take out the original batteries. Always use only new,
branded alkaline AA batteries (the polarity is clearly marked in the battery compartment). Once you have
replaced the batteries, turn the device on briefl y – its activation must be confi rmed by a beep. Do not use
rechargeable batteries. When fi nished using the device, take the batteries out.
Besides battery replacement, the Nanny does not require any special maintenance. We recommend that
you occasionally check the sensor pad in the crib to make sure that no moisture precipitates in the area
where the pad touches the mattress. You should turn the pad inside the crib by 180° once in a while, or turn
it over and air it. Clean the pad with a slightly moist cloth. (Do not use aggressive detergents.). Contact with
water can cause damage to the Nanny. The Nanny is supplied with an antibacterial tissue for disinfecting
the pad, if necessary. The frequency of cleaning does not affect the service life of the product. Protect the
sensor pad, supply cable and connector from mechanical damage (shocks, sagging, tensile stress, etc.). If
you detect any damage, contact the vendor or the manufacturer's service department directly (page 22).

BATTERY REPLACEMENT

CLEANING AND MAINTENANCE

EN
17
MFV52110