Getting Started; Switching On; Playing Discs - Pioneer SUPER AUDIO CD PLAYER PD-D9MK2-K Operating Instructions Manual

Getting started

Chapter 4
Getting started

Switching on

After making sure that everything is connected
properly and that the player is plugged in, push
the POWER button into the ON position to
switch the player on.
• Press CD PLAYER  on the remote to
switch the unit into standby.
POWER OFF
POWER
STANDBY
OFF ON PURE AUDIO

Playing discs

The basic playback controls for playing CDs,
SACDs, and MP3/WMA discs are covered
here. Further functions are detailed in Other
playback features on page 14.
CD PLAYER CD PLAYER
TIME
SACD/CD
1 1
4 4
7 7
CLEAR
ON
OPEN/CLOSE OPEN/CLOSE
DIMMER
LEGATO
LINK PURE AUDIO PURE AUDIO
2 2 3 3
5 5 6 6
8 8 9 9
0 0
ENTER ENTER
1 If the player isn't already on, press
POWER to switch it on.
Press  (OPEN/CLOSE) to open the disc
2
tray.
3 Load a disc.
Load a disc with the label side facing up,
using the disc tray guide to align the disc.
Once properly seated, press  to close the
disc tray.
Press  (play) to start playback.
4
Basic playback controls
The table below shows the basic controls for
playing discs.
Button What it does

Starts playback.
 Pauses a disc that's playing, or
restarts a paused disc.
/
Starts playback/stops a disc that's
playing.
(front panel
only) • While depressing /, press 
(front panel only). Counting from the
first track on the disc, playback will
begin from the track number
corresponding to the number of
times  is pressed.

Stops playback.
04
13
En