Rear Panel - Sony PVM-2950QM Operating Instructions Manual

1
2
3
AC IN
~
[n~'~
~
- LINE 1 - - LINE 2
~
-LINE 3 (INPUT) -
~VIDEOi ~VIDEOi
i i
G/Y VD
~~@ @2~ ~
- ·"""'" I... __ .
1[mi
Y/C Y/C
@~@
@~@
AUDIO AUDIO
@~@ @~@
[I]
AC IN socket
Connect the supplied AC power cord to this socket and
to a wall outlet.
[g]
LINE 1, LINE 2 connectors
VIDEO IN (BNC}
Connect to the video output of video equipment, such as
a VCR or a color video camera. Fm a loop-through
connection, connect to the video output of another
monitor.
VIDEO OUT (BNC}
Loop-through output of the VIDEO IN connector.
Connect to the video input of a VCR or another monitor.
Y/C IN (4-pin mini DIN} .
Connect to the Y /C separate output of a video camera,
VCR or other video equipment.
Y/C OUT (4-pin mini DIN}
Loop-through output of the Y /C IN connector. Connect
to the Y /C separate input of a VCR or another monitor.
AUDIO IN (phono}
Connect to the audio output of a VCR or to a
microphone via a suitable microphone amplifier. For a
loop-through connection, connect to the audio output of
another monitor.
AUDIO OUT (phono}
Loop-through output of the AUDIO IN jack. Connect to
the audio input of a VCR or another monitor.
~ LINE 3 connectors
R/R-Y IN, G/Y IN, BIB-YIN (BNC}
When the RGB input is selected (RGB key on the front
panel is lit), connect to the RGB signal outputs of a video
camera. When the R-Y, G/Y, B-Y input is selected (RGB
key is not lit), connect to the R-Y /Y /B-Y component
signal outputs of a Sony Betacam video camera.
B/B-Y
~ EXT
SYNC
I ~(g (?)1UTI
~
L'.!
CON AOL S
!:.]
R---L
@@
AUDIO
5
HD/COMP (BNC}
Connect to the H sync signal or composite sync signal
output.
VD (BNC}
Connect to the V sync signal output.
ldfftJ
External sync signal is selected automatically. See the
priority chart below.
Input~
·· ·· Tnpln-sfnc·'1g;tals
HD/COMP HSync Comp Sync
-
VD VSync -
-
G SynconG SynconG SynconG
Sync signals HSync
Comp Sync
SynconG
to be selected
VSync
AUDIO IN (phono}
Connect to the audio output of a VCR.
@]
SPEAKER UR terminals
Connect to speakers with 8 to 16 ohms impedance.
•Mhtl
Do not connect the speaker's cord to the monitor and to
an amplifier simultaneously, or an excessive electric
current migbt flow from the amplifier and damage thi?
monitor.
[fil
CONTROL S IN/OUT connectors
Connect to the CONTROL S connectors of a VCR or
several monitors. Then you can control the system with
a single remote commander.
•Udtl
If you connect CONTROLS IN to the other equipment's
CONTROLS OUT connector, you cannot operate the
monitor with the supplied remote commander.
5
I