Using The Remote Control; Programming A Universal Remote - Insignia NS-HSB318 User Manual

Using the remote control

1 Remove the plastic tab from the battery compartment before using the
remote control for the first time.
2 Point the remote control directly at the IR sensor on the front of the
soundbar. You must be within approximately 23 ft. (7 m) of the soundbar.

Programming a universal remote

If you program your universal remote to an Insignia TV, it will control your
soundbar's volume. To program your remote:
1 Go to www.insigniaproducts.com/remotecodes.
2 Find your remote's brand from the list of remote codes.
3 Follow the directions that came with your remote to program a remote
code. If several remote codes are provided, you may need to try several
until you find one that works.
Note: Make sure that you program the soundbar to a device on your
remote that is not in use.
Soundbar Home Theater Speaker with Bluetooth
IR Sensor
Cautions
• Do not spill water or any liquid on the remote
control.
• Do not place the remote control on a wet
surface.
• Do not place the remote control in direct
sunlight or near sources of excessive heat.
• If the remote control is not going to be used for
a long time, remove the battery to avoid any
damage that may be caused by leakage and
corrosion.
Note
To control your soundbar's volume you can use an
Insignia TV remote or program a universal remote.
Insignia TV remotes and universal remotes will not be
able to change your soundbar's audio source or DSP
sound mode. Use the controls on your soundbar or
the remote that came with it to change these
settings.
www.insigniaproducts.com 9