Mounting Your Soundbar On A Wall (Optional) - Insignia NS-HSB318 User Manual

Mounting your soundbar on a wall (optional)

You will need:
LEVELING EDGE Hold a level to the Leveling Edge of this template LEVELING EDGE
Drill a hole here Drill a hole here
20.43 inches (519 mm)
Select a location close to your TV and directly in Position the wall mount template on the wall where you Drill two holes in the wall where the template indicates, Wall Soundbar
front of the viewing/listening position. For best want to mount your soundbar, level the template, then then remove the template. Approx. 1/4 in
sound quality, choose a location where sound waves tape it to the wall. Wall (6.8 mm)
are not blocked by furniture or other obstacles. Wall Wall Wall Wall mount template
Secure two screws (not included) to the wall or wall anchors Position holes onto studs behind drywall or use anchors for mounting
Anchor (if required). The screws must protrude from the wall by
If you are mounting on drywall or concrete, insert wall about 1/4". Use a #10 wood screw (or similar), 1 1/2" in Warning: Improper installation can result in serious injury or damage to your soundbar.
anchors (not included) into the holes and use a hammer head must be approximately 1/4" to 3/8". length. The screw width must be about 3/16" and the screw Align the speaker hanging brackets with the screws, If necessary, seek the assistance of a professional.
Note: Make sure that the template is level. to make sure that the anchors are flush against the wall. then hang the soundbar on the screws.
Wall mounting template
Tape measure
1 Select a location close to your TV and directly in front of the
viewing/listening position. For best sound quality, choose a location
where sound waves are not blocked by furniture or other obstacles.
2 If you are mounting your soundbar to drywall, use the stud finder to find
the studs and mark the locations.
3 Position the supplied wall mount template to the wall where you want to
mount the soundbar. Make sure that the template is level and note if it's
aligned with a stud, then tape the template to the wall.
4 Drill two holes
template indicates, then remove the template.
5 If you are mounting on drywall without studs or on concrete, install wall
anchors (not included) into the holes you drilled, using the instructions
that came with your anchors.
Soundbar Home Theater Speaker with Bluetooth
Tools Needed
anchors (2) Wall
Screws (2) - #10 x 1 ½"
wood screw (or similar)
V1 14-0130
Level
Tape
(what size drill bit is needed?)
www.insigniaproducts.com
Stud finder
Drill and
(optional for wood
drill bit
stud installation)
Wall anchors (2)
Caution
Make sure that you use wall anchors that are suitable
to your wall type if you need to mount the soundbar
to drywall, concrete, or similar wall type.
Notes
• If you have drilled into a stud, wall anchors are
not required.
• If you cannot drill into wall studs and must drill
into drywall, concrete, or another type of wall,
wall anchors are required. See the instructions
that came with your wall anchors to determine
the drill bit size.
Hammer
Screws (2) - #10 x 1½" (3.8 cm) wood
screw (or similar) with approx.
¼" to 3/8" head
into the wall where the
Screwdriver
17