Insignia NS-SB212 Template
Insignia NS-SB212 Template

Insignia NS-SB212 Template

Wall mount template
Hide thumbs Also See for NS-SB212:

Advertisement

88 mm
Hold this template to the wall and use a level to
level it, then temporarily tape it to the wall.
Wall
Drill two holes at the indicated points.

LEVELING EDGE

Drill a hole here
Wall
Soundbar
Wall
6 to 8 mm
Anchor
(1/4 inches)
Fasten two screws (not supplied) to the wall. The
Remove the template from the wall.
screw heads should protrude from the wall
You must use suitable wall anchors (not supplied) if
approximately 1/4 in. (6-8 mm).
you are mounting on drywall, concrete, or other wall
Align the speaker hanging brackets with the screws,
The screw width must be about 3/16" and the
then hang the soundbar on the screws.
types.
screw head about 1/4" to 3/8".
799 mm
406.4 mm
Hold a level to the Leveling Edge of this template
Wall

Wall mount template

Locate / Position holes onto studs behind drywall or use anchors for mounting
Warning: Improper installation can result in serious injury or damage to your soundbar.
If necessary, seek the assistance of a professional.
LEVELING EDGE
Drill a hole here
12-0293

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NS-SB212 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Table of Contents