Table of Contents
Advertisement
Quick Start Guide
1. Charging the Battery Baton
l
l
1
Locking Ring
l
2
3
l
Power
l
Trickle charge
Note:
Fast charge
4
Batons with Testifire.
3. Removal & Replacement of
Smoke Capsules
Removal:
l
A
B
B
7
l
Replacement:
Spring Clip
l
Protector
l
C
l
B
B
Spring Clips
8
l
www.
testifire
.com
testifire
to
Preparation For Use
The charger can be connected to
a mains power outlet or a 12 volt
vehicle socket ( ). When connected,
1
the red Power LED will illuminate.
Connect the Battery Baton to the
charger and turn the locking ring
( & ).
2
3
The yellow Fast Charge LED will
illuminate ( ).
4
Charge times vary but can be
75-90 minutes when charging a
fully discharged Battery Baton.
When fully charged, the charger
will switch to Trickle Charge and
the green LED will illuminate ( ).
Use only NiMH Battery
(Testifire 1000 & 2000 series)
Release the upper access cover
( ) on the body of the Testifire by
7
opening it from the right hand side.
Note:
Testifire 1000 series units
only have one access cover.
Squeeze the two clips
B
of the
used capsule and gently pull the
capsule out.
Remove the capsule from its outer
carton and Anti-Static bag.
Remove the spring clip protector
cap from the new capsule
Holding the capsule by the spring
clips with the label on the
underside, carefully insert the new
capsule into the capsule port. Push
it into position, ensuring that the
clips spring out positively on both
sides of the capsule.
Close the access cover
A
®
MULTI STIMULUS DETECTOR TESTER
2. Inserting the Battery Baton
5
4
6
4. Removal & Replacement
of CO Capsules
A
D
E
9
E
Tip Protector
F
C
( ).
8
E
E
Spring Clips
10
securely.
l
To insert the Battery Baton, hold
the Testifire head unit by the
handle and depress the upper
spring button on the Battery Baton.
Align the button with the location
hole in the handle and push the
Battery Baton into the handle until
the button springs up through the
location hole ( ).
5
l
Insert the other end of the Battery
Baton into the Solo access pole and
depress the lower spring button.
Align it with the location hole and
push the Battery Baton further into
the pole until the button springs up
through the hole ( ).
6
(Testifire 2000 series only)
Removal:
l
Only replace the CO capsule when
it is empty. Turn Testifire off for five
minutes to allow the capsule to cool
down before removing it.
l
Release the lower access cover
( ) by opening it from the right
9
hand side.
l
Squeeze the spring clips
side and gently pull the capsule out.
l
Do not touch the tip of the CO
capsule as it may be hot.
F
Replacement:
Remove the capsule from its carton
l
and Anti-Static bag.
Remove the tip protector
l
Hold the capsule by the spring clips
l
with the label uppermost. Carefully
insert into position, ensuring that
the clips spring out positively on
both sides.
l
Close the access cover
D
E
on each
F
(
10
).
D
securely.
Advertisement
Table of Contents
