Sony SPP-M920 Service Manual page 16

2.2 Receive Section
2.2.1 RX Amps and SAW Filter
The purpose of the first RX amp is to provide enough gain that the noise figure of the RX section is fixed to as low a value as possible.
It must provide a good 50 ma tch to both the RX bandpass filter and the SAW filter. This amplifier must also have good power
handling capability due to the limited filtering which precedes it. The design employs a collector inductor to improve the output
power capability of the transistor. This form of matching also ensures that the gain of this stage is not too wide band further improv-
ing its performance by allowing it to effectively reject signals which are far out of its passband.
Directly following the first RX amp is the SAW filter. This filter is responsible for the bulk of the filtering in the receive section. It
provides more than 40dB of image rejection and TX carrier suppression. The insertion loss of this filter is relatively high due to its
SAW implementation. It has an insertion loss of less than 5 dB, typically 4dB. An amplifier is required before this SAW filter to keep
the noise figure low. If it were not present, the noise figure of the phone would increase by the 4dB loss associated with the SAW
filter.
The second RX amp provides a limited amount of gain. Its main function is to ensure that the mixer sees a good wideband match.
Measuring the RX gain from the BFA connector to the output of this amplifier will produce results as shown in Figure 4 below.
0dB
10dB/div
875
2.2.2 RX Mixer
The function of the mixer is to combine the incoming signal with a LO signal in order to convert the desired signal to the 10.7MHz
IF frequency. The mixer used for this task is a dual gate FET (CF739R). The LO and RF signals are placed on the gates of the FET
and the IF signal is coupled off of the drain. The FET provides conversion gain along with adequate power handling characteristics.
Both the RF and LO ports are shorted to ground by rectangular microstrip inductors. These inductors provide a high impedance at
both the RF and LO frequencies while presenting a very low impedance at the IF frequency. The mixer is followed by an emitter
follower which converts the high impedance output of the mixer to a 330 output suitable for directly driving the IF ceramic filters.
The gain for the pair (mixer and follower) is about 8dB (50 in, 330 out).
2.2.3 RX VCO and LO Buffer
The RX VCO is a Colpitt's type oscillator operating at about 450MHz with a frequency selective network tuned to about 900MHz on
the collector. The frequency of oscillation is controlled by a varactor diode in the tank circuit connected to the base of the transistor.
This diode is connected to the loop voltage form the RX synthesizer. Rough tuning is achieved with a variable chip cap. This
capacitor is used to center the tuning voltage to ensure reliable operation over a wide temperature range and also to compensate for
variances in component values.
The 450MHz LO for the PLL is coupled off the emitter of the VCO transistor. This is lightly coupled to ensure that the VCO is not
loaded by the PLL. The LO Buffer isolates the PLL from the VCO preventing the TX VCO from interfering with the RX VCO and
vice versa. The 900MHz RX LO signal for the Mixer is coupled off the collector of the VCO transistor.
925-928MHz Passband
902-905MHz Reject Band
Figure 4. RX Front Respons
– 16 –
975