Water Fill Adjustment - Maytag ATB1821AR series Service Manual

To avoid risk of electrical shock that can cause death or severe personal injury, disconnect unit from power before
servicing unless tests require power. Discharge capacitors through a 10,000-ohm resistor before handling. Wires
removed during disassembly must be replaced on correct terminals to ensure proper grounding and polarization.
Screw
Support assembly
(not replaceable,
order new ice maker)
Module assembly
(not replaceable,
order new ice maker)
Module Anchor screws (3)
NOTE: New fill cups are molded with two break-out slots
for a fill tube. This is done so that the same cup can
be used in several applications.
To install a new fill cup:
a. Disassemble ice maker per instructions above.
b. Using ordinary pliers on new fill cup, break out fill
slot required by your application.
c. Mount new fill cup and reassemble ice maker.
16025860
!
WARNING
Ice Maker bracket
Mold & Heater assembly
(not replaceable,
order new ice maker)
Thermal Fuse clip
Thermostat Retainer clip
Mold Anchor screws (2)
Ejector
Thermostat
(not replaceable,
order new ice maker)
Break out appropriate tab
to make slot for fill tube

Water Fill Adjustment

Turning the water level adjustment screw moves the
contact point in relationship with the contact ring
segment upon which it rides. Because the contact ring is
tapered, movement of the contact point causes variation
A - 4
Fill Cup
Shut-Off Arm
assembly
Stripper
©2005 Maytag Services