Moving The Control Panel - Kenmore 796.9139 Use & Care Manual

INSTALLATION INSTRUCTIONS

MOVING THE CONTROL PANEL

WARNING:
• Disconnect power before servicing.
• Replace all parts and panels before operating.
• Be careful of the sharp edge on the frame to avoid
injury.
• Failure to follow these instructions can result in death
or electric shock.
Disassemble
Push to open the cap on the right side of the control
1
panel.
Remove the screw under the cap and set it aside.
2
Slide the control panel about an inch to the right to free it
3
from the clips.
Control Panel
Drop the front of the panel down and disconnect
4
the wire harness. Remove the panel and set it aside.
Wire harness
Hook
Lift the top plate slightly to remove it.
5
Cap
Frame
Plate
18
Push to open the cap on the right side of the lower
6
cover.
Remove the screw under the cap and set it aside.
7
Slide the lower cover about an inch to the right to
8
free it from the clips. Set cover aside.
Lower cover
Remove the screws holding the safety cover in place
9
and set the screws and the cover aside.
Safety Cover
Assemble
Connect the wire harness on the control panel.
1
Make sure to push the connector until the hook clicks
into place.
CAUTION:
• If the wire harness is not connected properly, the
dryer may not operate.
Cap
Frame
Wire harness