Invacare® Homecare Beds
4.5 Assembling the Spring Fabric
1. Lift the head spring C away from the bed frame to give
slack to the fabric.
2. Connect the spring fabric A together with the links B
provided.
22
4.6 Adjusting and Reconnecting the Head
Section Pull Tube
1. To disconnect the head pull tube assembly A from the
side frame of the foot spring, remove the hitch pin E
and grommet/washer F from the clevis pin G.
2. Extend the inner pull tube shaft C manually until the
spring button "clicks" into the adjustment hole of the
outer pull tube D.
3. Connect the pull tube end assembly A to the lift arm
of the head spring as follows:
a. Insert the clevis pin G into the lift arm slot H.
b. Replace the grommet/washer F.
c. Secure with hitch pin E.
1114836-H-05