Table of Contents
Advertisement
Cleaning
and
caring
for your
range
Your range is designed to be easy to clean. You will usually wipe off
spills and spatters
when they happen.
but you will sometimes
want to
.*
clean under and behind the control knobs and surface units. This section
will tell you how to remove those, and what to use when cleaning.
Removing
and replacing
surface
unit control
knobs:
1. Be sure the control knobs are set to "OFF,"
2. Pull the black knobs straight off.
3. If the control has a chrome trim ring. pull it straight off.
4. Wash the knobs (and trim rings) in warm, sudsy water.
5
Replace the tnm rings first.
If the control
spring
was removed,
put
it back
exactly
as shown
on the left..
. small
end first.
Pull knob and trim
ring
6
Hold the black knob so it points to "OFF."
Push it straight back on.
straight
out.
Remember
Removing
and replacing
oven
control
knobs:
how the spring
goes.
1 Be sure the knobs are set to "OFF"
2
Pull each knob strarght off.
3
Wash the knobs in warm. sudsy water.
4
The knobs are not interchangeable.
Make sure you put the
adjust-
able
Oven
Temperature
Control
Knob
on the right place, and the
nonadjustable
Oven Selector Knob on the other.
Removing
surface
units
and reflector
bowls:
1 Frrst. be sure the Surface Unrt Controls
are all "OFF"
and that the
surface units are cool.
2
Lift each surface unit about an inch (2.5 cm) at the edge away from the
plug-in
(receptacle)
Pull the unit straight away from the plug-in.
Do
To remove
surface
unit,
lift and pull
straisht
out.
nor wash surjoce units; they will burn themselves
clean during normal
use
3
L.lft out the ref!ector bowls.
12
Advertisement
Table of Contents
