Table of Contents
Advertisement
c)
Turn on the heater if hotter solution is desired.
NOTE: The pump must be ON when the heater is
ON.
d) Turn ON the vacuum switch. You may now begin
the cleaning process.
7.
Depressing the valve trigger on the wand will allow the
solution water to flow.
8.
Foaming may occur as dirty solution is recovered. Ex-
cessive foaming can be counteracted with liquid de-
foamer (follow the chemical manufacturers directions).
Do not allow foam to rise into or near the float assembly
in the recovery tank. Use defoamer or empty and flush
the recovery tank.
9.
When finished cleaning, turn off the heater, vacuum
and pump switches.
The DELUXE 15 extractors are designed and manufactured to provide years of trouble free service with a minimum of maintenance
and service. The following recommendations are intended to assist the operator and Service Technician in performing routine
maintenance.
Failure to follow these recommendations can result in damage to your machine and diminished performance.
Warning: Always unplug your machine before performing any service. Severe personal injury could result if the electrical
power is not disconnected.
1.
Always follow through with the recommended prestart-
up checks found in the Preparation and Operation sec-
tion of this manual.
2.
Store your machine in a dry, protected area. Do not
expose this machine to rain, standing water or freezing
temperatures.
3.
We recommend a good, thorough cleaning after each
use.
a)
Clean the cover, float assembly and gasket.
b) Clean out the recovery tank with fresh water mak-
ing sure all deposits or debris are removed.
c)
Check and clean the inlet strainer in the solution
tank periodically with clean water. Make sure the
strainer is properly in place to protect the pump.
d) Wipe the machine down with a damp cloth.
OPERATION
10. Always drain the recovery tank after each use; simply
pull the plug from the tote hose on the back of the tank
and drain. Dispose of the recovered water properly.
11. To drain the solution tank, attach the optional drain or
"pump out" hose (part number 204172) to the acces-
sory quick connect on the front of the machine. Place
the open end of the hose into a bucket and turn on the
pump switch. When empty, turn off the pump switch
and remove the hose from the quick connect.
12. All switches should now be OFF, unplug the power
cord(s) from the electrical outlet before doing any clean-
up.
13. After each use clean the cover, float assembly and gas-
ket. Do not reinstall the cover until the next use, this
will allow the recovery tank to dry out.
SERVICING
4.
The jet tips and strainer/check valves on the wand will
need cleaning after repeated use. First remove the jet
caps, then the jet tips and strainer/check valves. Soak
them in vinegar until visible deposits are dissolved, then
scrub with a soft bristle brush. Reassemble.
Jet tips and strainer/check valves should be replaced
once a year because they tend to erode under extended
use.
5.
AN AUTHORIZED SERVICE CENTER SHOULD PER-
FORM SERVICE TO THE PUMP AND VACUUM
MOTOR. The tank is hinged to provide easy access to
the internal components.
Additional service information is available from your
local Pacific Distributor or through our Technical
Service Department.
5
Advertisement
Table of Contents
