Table of Contents
Advertisement
INTRODUCTION
The Pacific DELUXE 15 Carpet Extractor Machine is built from highly durable polyethylene and is intended for commercial use.
The solution tank holds 15 gallons and the recovery tank holds 13 gallons. A 12-inch, two jet, high pressure wand with 15 feet
each of solution and vacuum hoses is provided.
The DELUXE 15 is designed with a variable pressure pump that can generate up to 250 psi to deep clean carpets without
damaging fibers.
The heavy-duty three-stage vacuum motor on the DELUXE 15 is capable of 137 inches of water lift. This thoroughly extracts the
dirty solution from the carpet fibers and reduces the drying time.
DELUXE 15 machines are designed for easy maneuvering by one person. They have large 10" diameter rear wheels and front
swivel casters. The machine is 21" wide x 28" long x 35" high and weighs just 80 pounds.
The DELUXE 15 is built with a hinged tank that provides easy access to internal components for servicing.
Grounding Instructions
This machine must be grounded. If it should malfunction or break down,
grounding provides a path of least resistance for electric current to reduce the
risk of electric shock. This machine is equipped with a cord having an
equipment-grounding conductor and grounding plug. The plug must be in-
serted into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
WARNING - Improper connection of the equipment-grounding conductor
can result in a risk of electric shock. Check with a qualified electrician or
service person if you are in doubt as to whether the outlet is properly grounded.
Do not modify the plug provided with the machine - if it will not fit the
outlet, have a proper outlet installed by a qualified electrician.
This machine is for use on a nominal 120-volt circuit, and has a grounded plug
that looks like the plug illustrated in figure A. A temporary adapter that
looks like the adapter illustrated in figures B and C may be used to connect this
plug to a 2-pole receptacle as shown in figure B if a properly grounded outlet
is not available. The temporary adapter should be used only until a properly
grounded outlet (figure A) can be installed by a qualified electrician. The
green colored rigid ear, lug, or the like extending from the adapter must be
connected to a permanent ground such as a properly grounded outlet box
cover. Whenever the adapter is used, it must be held in place by a metal screw.
NOTE: In Canada, the use of a temporary adapter is not permitted by the
Canadian Electrical Code
EXTENSION CORDS
Use only three-wire 14/3 or larger gauge approved extension cords that have
three-prong grounding type plugs and three-pole receptacles that accept the
appliance's plug. Replace or repair any damaged cords or plugs.
NOTE: Do not use adapters shown in figures B & C in Canada
When servicing, refer to authorized person only. Use only identical replace-
ment parts.
2
Advertisement
Table of Contents
