Loading The Batteries; Inserting An Sd Card (Optional) - Jenoptik JDC 3.0S User Manual

LOADING THE BATTERIES

The camera uses 3x AAA alkaline or rechargeable batteries.
1. Slide the Battery Door and lift it open.
2. Insert the batteries according to the polarity indication engraved on
the battery contact.
3. Close the battery compartment cover.
Checking the Battery Level
The battery level indicates the power of the batteries.

INSERTING AN SD CARD (OPTIONAL)

The camera is equipped with 32 MB of internal memory that can be used for storage as soon as
you start taking pictures or recording video clips. Besides, the camera can use a Secure Digital (SD)
memory card to store images and/or video clips. If no SD card is inserted in the camera, all pictures/
video clips recorded by the camera will be stored in the internal memory. When SD card is inserted in
the camera, all files recorded by the camera will be stored on the SD card.
Status
Memory card is not inserted.
Memory card is inserted.
To insert the SD card:
Insert the memory card in the direction as shown in figure, then gently but firmly push the SD card into
the SD card slot as far as possible. When the card is fully engaged, a click can be heard.
Note: NEVER forcefully push the card into the camera
to avoid damaging both the card and/or the camera.
To remove the SD card:
Press the memory card into the slot then release. When the card
is partially ejected, pull it out.
Note : If the format of SD card is FAT32 or NTFS, the camera will format this SD card without
any warning and will change the format to FAT16 file format. Existing files or pictures on the card
will be deleted.
Full Low
6
Empty
Memory in Use
Internal Memory
Memory Card
GETTING STARTED