Table of Contents
Advertisement
GETTING STARTED
INSERTING THE BATTERIES
The camera is powered by two AA-size alkaline batteries or rechargeable Ni-MH (min. 2000 mAh /
1.2V to get 250 shots) batteries.
1. Slide the battery cover open.
2. Insert two AA-size alkaline batteries with the
positive(+) and negative(-) poles matching the
directions indicated inside the battery room.
3. Close the battery cover.
Low Battery Indicator
A low battery indicator
Batteries should be replaced promptly when the low batteries indicator appears.
Note:
• Do not use manganese batteries. Manganese batteries cannot supply sufficient power to
support camera operation.
• Replace all batteries at the same time. Never mix old and new batteries.
• Remove batteries from the camera if you do not plan on using it for more than two weeks.
• The camera body may feel warm after extended use. This is normal.
Important: Users are not recommended to buy their own adaptor and use it on the camera as
power supply.
INSERTING A MEMORY CARD
You can use SD Card with this digital camera. The memory card slot is located beneath the battery
cover, adjacent to the battery compartment.
1. Be sure that the camera is turned off.
2. Slide the battery cover and open it.
3. Insert the SD card as shown in the diagram.
4. Close the battery cover.
appears on the LCD screen when the batteries are nearly exhausted.
640
320
160
5
Advertisement
Table of Contents
