Gaggia VELASCA RI8260 User Manual page 23

The AquaClean filter is
installed, but the
descaling message
appears.
The descaling message
appears before 8 filters
were replaced.
The filter does not fit.
There is water under the
machine.
The AquaClean filter was not
correctly activated during first
installation.
After 8 filter replacements, you
need to descale the machine
You did not activate the
AquaClean filter correctly during
first installation.
You placed the AquaClean filter
after having used the machine
for a while.
You did not activate the
replacement filter in the machine
menu.
You did not replace the filter
when the filter symbol started
flashing.
You need to remove air from the
filter.
There is still water in the water
tank.
You try to install another filter
than the AquaClean filter.
The drip tray is too full and
overflowed.
The machine is not placed on a
horizontal surface.
Note: If you are unable to solve the problem with the information in this
table, contact your local reseller or an authorized service center. Contact
details are included in the warranty booklet supplied separately or visit
www.gaggia.com/n-m-co/espresso/world-wide or www.gaggia.it/n-m-
co/espresso/contact.
Follow the instructions on the display
until you receive confirmation that the
filter has been activated.
First descale the machine and then
install a new AquaClean filter. This will
reset the filter counter to 0/8. Always
confirm filter activation in the machine
menu, also after filter replacement.
First descale the machine and then
install a new AquaClean filter. Always
activate the filter in the machine menu.
Let air bubbles come out of the filter.
Empty the water tank before you
install the filter.
Only the AquaClean filter will fit.
Empty the drip tray when the drip tray
full indicator pops up through the drip
tray. Always empty the drip tray before
you start descaling the machine.
Place the machine on a horizontal
surface so that the drop iray full
indicator works properly.
English
23