Martek Chicken Switch Instruction Manual page 9

STEP 3 – Connect the cable to the hand-held controller and the other end to the PB-16
actuator.
STEP 4 – Carefully position the PB-16 over your button, hold the magnet firmly against
the switchgear door, and the rotate the magnet lever clockwise to the ON position.
STEP 4 – At this point the actuator should be firmly attached to the switchgear door with
the plunger tip over your button.
© MarTek Limited. All rights reserved.
PB16 Operating Manual
PB16‐033117 v0
7