Pinch Point Hazards; Radio Frequency; Battery Information; Removing And Replacing The Batteries - Martek Chicken Switch Instruction Manual

2.4

Pinch Point Hazards

THIS EQUIPMENT HAS MOVING PARTS AND A MAGNET THAT PRESENT PINCH POINT HAZARDS
Care must be taken to prevent injury when handling the equipment.
The PB-16 is a motorized device with moving parts and a strong magnet that will produce the opportunity
for pinch point hazards. In order to prevent a pinch point injury, the following procedures should be
followed:

Be sure that the magnet is ALWAYS in the OFF position unless it is being held again a ferrous
surface. The magnet is very strong and will be attracted to any nearby ferrous material and could
unexpectedly cause a pinch point hazard.

Turn the magnet to the OFF position before removing it from a ferrous material.

Store the PB-16 actuator with the magnet in the "OFF" position.
3.0

Battery Information

THIS EQUIPMENT USES 'AA' ALKALINE BATTERIES.
DO NOT attempt to utilize batteries other than the type AA.
The PB16 uses common alkaline AA batteries. Rechargeable AA batteries will also work as will
Energizer Lithium AA batteries. Do not attempt to use batteries other than AA.
3.1

Removing and Replacing the Batteries

Remove the thumbscrew on the bottom of the hand-held controller and remove the battery cover
to access the batteries. Install 8 – AA batteries.
Replace the battery cover and thumbscrew.
© MarTek Limited. All rights reserved.
PB16 Operating Manual
PB16‐033117 v0
3