Table of Contents
Advertisement
SPECIFICATION
Wall Mounted Radiant Gas Heater
Model Type
Model No
Gas Type
Gas Pressure
Gas consumption
Injector Size
Hose Connection
Net Weight
AGA Approval No.
Dimension and Clearance Detail
Before installing the wall mounted heater, make sure the wall must be capable to supporting the weight of the
heater. Place the mounting bracket in position. The heater shall be firmly and securely attached to the wall.
WARNING : MINIMUM CLEARANCES TO COMBUSTIBLE MATERIAL,
!
FROM TOP 500mm / add TGHSHIELD(not included) for 300mm,
SIDE 1000mm, MINIMUM MOUNTING HEIGHT 2000mm.
Note: Additional heat shield (TGHSHIELD) is required for 300mm overhead clearance and it's available at extra cost.
PRODUCT OVERVIEW
Wall Mounted
TGH34WN
NG
1.00 KPA
34 Mj/h
1.40mm*4
5/8"-18UNF(3/8" SAE)
11.5 kg
8442 G
Intallation Clearances
This appliance must only be used in a well ventilated
area.
The following clearance should be followed:
The heater should not be installed:
- Where heat ignition can cause damage to gas
cylinders/lines
- Near other combustible materials.
- In open locations subject to rain.
Heater should be installed to allow adequate:
- Clearance around air openings to combustion
chamber.
- Clearance from combustible material.
- Provisions for accessibility and clearance for
combustion and ventilating air supply.
6
Advertisement
Table of Contents
