Table of Contents
Advertisement
Check For Gas Leaks
Never test for leaks with an open flame. Prior to first
use, at the beginning of each season, you must check
for gas leaks. Follow these three steps:
Make a soap solution by mixing one part liquid
1.
detergent and four parts water.
4 parts water
1 part liquid detergent
2. Pull the black string down until 'click' will be heard
and then release, then turn on gas at source.
TURN ON (Red)
TURN OFF (Black)
3.
Apply the soap solution to all visible gas connections.
If bubbles appear in the soap solution the
connections are not properly sealed. Check each
fitting and tighten or repair as necessary.
NG
WARNING
!
If you have a gas leak that cannot be repaired
by tightening, turn off the gas at the source,
disconnect fuel line from your heater and call
(03) 9562 3455 or your gas supplier for repair
assistance.
USE AND CARE INSTRUCTIONS
NG
!
GAS REQUIREMENTS
TGH34WN(NG) Model:
This appliance is for use with Natural Gas only.
Ensure that inlet pressure to the regulator does
not exceed 5.0 Kpa.
The approved inlet pressure to be 1.0 Kpa.
WARNING
!
Failure to read and follow the Use and Care
Instructions could result in a fire or explosion
that could cause serious bodily injury, death
or property damage.
11
!
Advertisement
Table of Contents
