Table of Contents
Advertisement
Heater Lighting Instructions
Before each use, check all hoses for cracks, nicks, cuts,
burns or abrasions. If a hose is damaged in any way, do
not use your heater before replacing the hose with an
authorized part from the Parts List. Also make sure all
gas supply connections are securely tightened.
Familiarize yourself with the safety and Use and Care
Instructions in this Manual. Do not smoke while lighting
heater or checking gas supply connections.
Always light the heater standing to the side of the
heater, never light the heater standing in front.
WARNING
!
Failure to replace a faulty hose, secure gas supply
connections before proceeding to the Lighting
Procedures could result in a fire or explosion that could
cause serious bodily injury, death, or property damage.
TURN ON THE HEATER
1. Turn on the gas source.
2. Pull the red string down and 'click' will be heard and
continue to hold for 10 seconds. The tiles should turn
to red color. Release the string.
3. If the burner does not ignite, turn off the gas source .
Wait at least 5 minutes for gas to clear, then retry. If your
heater still fails to light, turn gas source OFF. Wait 5
minutes for gas to clear and then conduct a gas leak
test. If no leaks are detected, repeat the lighting procedure.
TURN OFF THE HEATER
1. Pull the black string down until 'click' will be heard and
then release. The tiles should turn from red to black.
2. If the heater does not turn off, repeat step one.
3. Turn off the gas supply.
4. When the heater is not in use, please turn off the gas source.
LIGHTING INSTRUCTIONS
!
12
TURN ON (Red)
TURN OFF (Black)
Advertisement
Table of Contents
