Lubrication - Husqvarna MZ 52 Operator's Manual

LUBRICATION

Lubrication Schedule
12/12 1/52 1/365
12/12 Every year
1/52 Every Week
1/365 Every day
General
Remove the ignition key to prevent unintentional
movements during lubrication.
When lubricating with an oil can, it must be filled
with engine oil.
When lubricating with grease, unless otherwise
stated, use high grade molybdenum disulphide
grease.
For daily use, the machine must be lubricated
twice weekly.
Wipe away excess grease after lubrication.
It is important to avoid getting lubricant on the
belts or the drive surfaces on the belt pulleys.
If this occurs, clean them with spirits. If the
belt continues to slip after cleaning, it must be
replaced. Gasoline or other petroleum products
must not be used to clean belts.
28
Lubricate with grease gun
Filter change
Oil change
Level check
IMPORTANT INFORMATION Use minimal
lubrication and remove excess lubricant so that
is does not come into contact with belts or belt
pulley drive surfaces.
WARNING! Escaping hydraulic oil under
pressure can have sufficient force to penetrate
the skin, causing serious injury. If injured by
escaping fluid, see a doctor immediately.
Serious infection or reaction can develop if
medical treatment is not administered.
25h 50h 100h 200h 300h