Kenwood KS101G Series Instructions For Use Manual page 25

FIXING THE OVEN
Introduce the oven into the furniture opening
and fix it with 4 screws (not supplied) as
figure 5.2. It is essential that the oven rests
on a surface which will support its weight,
as the screw fixing is only complementary.
Adjust the hinges of furniture doors
adjacent to the oven to allow a 4-5 mm gap
between the furniture door and the oven
frame.
IMPORTANT:
To avoid damage to the lower trim
Fig. 5.2
please note the following instructions.
The lower trim is designed to allow for good
air circulation and the correct opening of
the oven door.
To ensure the trim is not damaged due to
the appliance being placed on the floor, the
appliance should be suitably supported as
illustration here below.
After installation the appliance door should
be slowly opened to ensure no damage
has occurred.
No responsibility for lower trim damage
will be accepted if these instructions
have not been followed.
Oven
door
Lower trim
Air flow
Fig. 5.3
25